Parker’s hydraulic tube bender, HB632, is powered by 10,000 psi of pressure to bend steel and stainless steel tube up to 2” and 50mm O.D., and pipe up to 1 ½”. The hydraulic power, size capabilities and accurate bends make this draw bender a great choice for high production bending.
Technical Characteristics:

• Minimum components required with the HB32 bender are a hose assembly, hydraulic pump, and a radius slide and clamp block, which match the tube/pipe O.D. to be bent.
• Radius blocks for 1 ¾” through 2” O.D. require an adapter plate.
• The maximum bend angle is 180° with radii from 1 ¼” to 8”.
• If mandrels are used, the HB632 hydraulic bender must be bolted to a table, and will also require the use of a mandrel rod and mandrel rod stop assembly which holds and supports the end of the mandrel rod in alignment with the tubing.
• Requires a hydraulic pump which is sold separately.

Download Catalogue Here